Home / Course catalog -> Search for "Free course" / CAN-O-MAT – Swing-flanging - Conversio... (COM_045)

05 - CAN-O-MAT

CAN-O-MAT – Swing-flanging - Conversion when changing the diameter (Expert) (COM_045)


Description
When changing the can-body diameter, you must replace the entire tooling. The tools to be replaced include the upper and lower swing-flanging tools (one per spindle sleeve), the two center stars and the plate. A very precise working method is required, particularly for the correct alignment of the center stars to the tools. This training shows the exact procedure for replacing the tooling and then setting the correct height of the flanging unit.

CAN-O-MAT / COM I / COM II / mechanical setup
Content
  • Safety instructions
  • Conversion when changing the diameter for swing-flanging
Completion rules
  • All units must be completed